How To Reverse A Hunter Remote Control Fan

In terms of troubleshooting Hunter ceiling fan remote controls, much of the troubleshooting will be similar to troubleshooting other fans:

Brand sure that the power is turned on to the fan. This may seem similar a rudimentary or obvious affair, and yes we practice start at the obvious before we motion onto the not and so obvious.
Attempt using the remote to plough on the fan. If you cannot get the fan to turn on at all using the remote, pull on the pull chain and set the fan to the highest speed. Similarly, effort to turn on the light past using the remote. If no luck, turn on the low-cal past pulling the light pull chain.
Now, nosotros know the buttons don't work – did you try to modify the battery?
Next, let'due south cheque the dipswitches. Open the battery compartment on the back of the remote control. Inside hither are dip switches. You'll need to verify these against the fan. In gild to do so, you'll need to remove the canopy of the ceiling fan. Check the remote and compare the dip switch settings to the ones inside of the fan. They will be located on the ceiling fan receiver, within of the fan'southward canopy. The dip switch settings on the remote and the ones inside of the fan must be the same, or there will be problems with the fan non communicating with the remote properly.

Another common consequence related to dip switches, is the fan turning on or off by itself. This can exist caused by a neighbor, or a roommate having a remote with the same dip switch settings as yous past blow. To rectify this, you need to change the dip switches. In whatsoever case, make sure the remote dip switches always are positioned the same as the dip switches within of the fan.

Ceiling Fan Dipswitch — This film shows where the dipswitches are located on a fan remote, and what they look similar.

Once you're done checking the dipswitches – did y'all replace the battery? I know, we mentioned this before – only something you demand to check. One way to tell the batteries are getting low, is if the remote will only piece of work when close to the fan. Keep in heed the point will not get through walls, so you should exist in the same room.

If you're notwithstanding having issues, bank check the antenna isn't blocked inside of the canopy. While looking within of the canopy, come across if at that place is any frayed wires, corroded wires, or etc. Run across if the receiver, or any other parts appear damaged or even melted.

Once troubleshooting is completed, turn the wall switch back on for v seconds.

Plow the remote back on and endeavour once more.

Did the to a higher place aid you to troubleshoot your Hunter ceiling fan remote? If yous're notwithstanding having troubles, why non make full out our annotate form and let usa know. Or, if the troubleshooting worked out, feel free to permit us know about that equally well. You can also post on our Facebook page every bit well!

Source: https://hunter-ceiling-fans.com/hunter-ceiling-fan-how-to/troubleshooting-hunter-fan-remote-controls/